Gw-instek GSP-827 User Manual Bedienungsanleitung PDF herunterladen (Seite 6)

2.7GHz Spectrum Analyzer Operation Manual

⎯ ⎯

FOR UNITED KINGDOM ONLY

NOTE: This lead / appliance must only be wired by competent persons

WARNING: THIS APPLIANCE MUST BE EARTHED

IMPORTANT: The wires in this lead are coloured in accordance with the following code:

Green/ Yellow: Earth

Blue: Neutral

Brown: Live (Phase)

As the colours of the wires in main leads may not correspond with the colours marking identified in

your plug/appliance, proceed as follows:

The wire which is coloured Green & Yellow must be connected to the Earth terminal marked with

the letter E or by the earth symbol or coloured Green or Green & Yellow.

The wire which is coloured Blue must be connected to the terminal which is marked with the letter

N or coloured Blue or Black.

The wire which is coloured Brown must be connected to the terminal marked with the letter L or P

or coloured Brown or Red.

If in doubt, consult the instructions provided with the equipment or contact the supplier.

This cable/appliance should be protected by a suitably rated and approved HBC mains fuse: refer to

the rating information on the equipment and/or user instructions for details. As a guide, cable of

0.75mm

should be protected by a 3A or 5A fuse. Larger conductors would normally require 13A

types, depending on the connection method used.

Any moulded mains connector that requires removal /replacement must be destroyed by removal of

any fuse & fuse carrier and disposed of immediately, as a plug with bared wires is hazardous if a

engaged in live socket. Any re-wiring must be carried out in accordance with the information

detailed on this lable.

Use and Wear

CAUTION

• Do not exceed +30 dBm into the RF INPUT or +30 dBm reverse power into the TG OUTPUT.

• Do not place any heavy object on the instrument.

• Avoid severe impacts or rough handling that could damage the GSP-827.

• Use electrostatic discharge precautions while handling and making connections to the GSP-827.

• Do not place wires into the connectors of the GSP-827, only mating connectors and adapters.

• Do not block or obstruct cooling fan vent opening on side panels or on the rear panel of unit.

• This equipment is not for measurements performed for CAT II, III, and IV.

1 2 3 4 5 6 7 8 9 10 11 ... 96 97

Keine Kommentare

Gw-instek GSP-827 User Manual Bedienungsanleitung Seite 6